Plastic Material Introduction
ABS Cycolac GPM5500 : SABIC Innovative Plastics B.V.
The customer not supply the grade of material, so we choose a general material.
1. Melt Density 0.93839 g/cu.cm
2. Solid Density 1.0541 g /cu.cm
3. Ejection Temperature 85 deg.C
4. Recommended Mold Temperature 60 deg.C
5. Recommended Melt Temperature 250 deg.C
6. Absolute Max. Melt Temperature 290 deg.C
7. Melt Temperature Minimum 230.0 deg.C
8. Melt Temperature Maximum 270.0 deg.C
9. Mold Temperature Minimum 40.0 deg.C
10. Mold Temperature Maximum 80.0 deg.C
11. Maximum Shear Rate 50000.00 1/s
12. Maximum Shear Stress 0.300 MPa
Part Introduction
Cooling System Design
The cooling system is shown by picture, the diameter of channel is 8.0mm.
Case 1
Feed System Design
1x2 cavities, three plates mold, Cold runner +Pin gate, the size is shown by picture.